RMS 540

RMS 540
RMS.. series lighting fixtures are ideally suited for ON and OFF-SHORE applications and all kinds of industries where there is an high level of corrosion. Both body and glass frame are made of stainless steel AISI304 and manufactured from a single sheet of steel with no invasive mounting holes, to minimize the risk of water ingress through the housing. Out of holes for power supply cable, whatever protected by a suitable cable gland (available upon request), there are no passing through holes between inside and outside of luminaire. Therefore during the time there is no risk of IP rating decrease as it would be possible where, for fixing devices, there are through holes and relevant gaskets.
Design has been studied to allow operator working with free hands and no need to
support any part of lighting fixture. One person can take care of start-up or maintenance without any aid and assistance. Due to inorganic materials like stainless steel and glass, RMS.. series lighting fixtures are 95% recyclable; only components and insulation of single core wires need some more care.

TECHNICAL FEATURES

Material  


 
AISI304 stainless steel, 0,8mm thickness and transparent part in tempered glass (AISI 316 L version available upon request)

 
IP rating
 
IP66
 
Ambient temperature range -20°C to +60°C
Approvals
 
Compliance with Electromagnetic Compatibility (EMC) according to European Directive 2004/108/CE
 
Gaskets
 
Special cross-section tightness gasket, silicon rubber made (closed cell), located in housing channel between body and window frame.
 
Entries

 
Body complete of two 21mm Ø through holes (on one side) for cable entry, one complete of metallic plug with M20 locknut and gasket and the other one with temporary plastic plug to prevent dust ingress.
Hardware 
and screws
AISI304 Stainless steel external hardware and screws
 
Lamps

 
RMS series lighting fixtures are suitable for two pins fluorescent lamps G13 socket Philips TL-D or equivalent (lamps excluded)
 
Ballast
 
Electromechanical ballast with starter and capacitor
 
Rated operation voltage (UE)
 
230 V


 
Frequency
 
50 Hz
 
Power factor
 
> 0,9
 

Accessories available
upon request
 

Wiring with High frequency electronic ballast (220-240 V 50-60 Hz) / Pole mounting kit / Ceiling mounting kit / Suspension mounting kit / Wall mounting kit / 3°- 4° through holes opposite side

 

Operating principles

 
Available RMS.. lighting fixtures for emergency service of one tube:
- 90 minutes; guarantees 60’ duration with constant flux (emergency lumen factor 18%) and 30’ with decreasing flux
Photometric light curves